Skip to main content
Quotes & Budgeting6 min readBy Slab Mates Editorial TeamPublished (Updated )

Questions to Ask When Requesting a Concrete Quote

Two concrete quotes for the exact same area can sit thousands of dollars apart—usually because they are not pricing the same job. Asking clear, specific scope questions upfront protects both your budget and the finished slab.

Structural foundation grid drawings with an aluminium scale ruler, calculator, steel tape measure and concrete core sample.
Structural foundation grid drawings with an aluminium scale ruler, calculator, steel tape measure and concrete core sample.

Key takeaways

  • ✓Compare quotes line-by-line on excavation/spoil removal, compacted base depth, slab thickness, concrete MPa grade and steel mesh size.
  • ✓Ask explicitly whether concrete pumping, control-joint saw-cutting and site clean-up are included or provisional.
  • ✓Confirm trade licensing/registration requirements in your state or territory and check public liability insurance currency.
  • ✓Never accept verbal engineering changes—any alteration to an engineered plan must be approved in writing by the project engineer.

1. What excavation, spoil removal and base prep are included?

A headline "per square metre" figure means very little until you know whether site stripping, tip fees for excavated soil, and compacted crushed-rock base are inside the number or excluded as "site to be supplied level by owner".

Ask how potential rock, buried old footings or soft wet soil pockets are handled if encountered during digging, so variation rates are transparent before machines arrive.

2. What slab thickness, concrete grade and steel mesh are specified?

For engineered house and commercial slabs, every quote should follow the exact structural drawings—matching beam dimensions, concrete compressive strength (e.g. N25, N32 or special-class mixes) and reinforcement designations (e.g. SL72, SL82, SL92 on compliant chairs).

For non-engineered external paths or driveways where the contractor proposes the build-up, ask for the thickness in millimetres, mesh type, chairing method and concrete MPa grade to be written directly onto the quote.

  • Slab thickness (in mm) and compacted roadbase thickness (in mm).
  • Concrete compressive strength (MPa), aggregate size and finish type.
  • Reinforcing mesh code (e.g. SL72 vs SL82) and isolation joint foam locations.
  • Method and timing of shrinkage control joints (tooled vs diamond saw-cut).

3. Are concrete pumping, washout and clean-up included?

Line pumps and boom pumps save hours of heavy barrowing and keep concrete placement continuous, but pump hire is a real cost. Clarify whether pump hire is included in the lump sum, charged at cost, or not needed due to direct chute access.

Also confirm where concrete washout will be contained safely—washing cement slurry into street gutters or stormwater drains is unlawful and causes environmental fines.

4. Licensing, insurances and written variations

In Australia, contractor licensing thresholds, written home-building contract rules and deposit caps vary by state and territory regulator. Before paying a deposit, verify applicable trade licensing/registration for your jurisdiction, confirm current Public Liability Insurance, and ensure payment stages align with completed milestones.

Frequently asked questions

What information helps a concreter give an accurate first quote?+

Dimensions (length, width, target thickness), suburb/location, engineering or architectural PDFs (if applicable), preferred finish, and a couple of photos showing street parking and side-access width make quoting much faster and sharper.

Why do quotes mark rock excavation as an exclusion or provisional rate?+

Without full borehole coverage across a trench footprint, subterranean rock floaters or shale ledges cannot always be seen from the surface. Setting clear hourly or per-cubic-metre rock rates beforehand keeps surprises fair.

References & Australian industry guidance

General educational summary only. Always consult a qualified structural engineer, geotechnical practitioner or local building authority for site-specific compliance.